请教导入*.inp文件时出现的问题

ywy2002

在导入*.inp文件时，在信息栏出现以下问题，提交分析作业后，对ＩＮＰ文件的预处理没有通过，请问如何解决？
A new model database has been created.
The model "Model-1" has been created.
The model "Job-100" has been created.
The part "TOOL-MESH-1" has been imported from the input file.
The part "WORKPIECE-MESH-1" has been imported from the input file.
WARNING: Node-based surfaces are not yet supported in ABAQUS/CAE. The following node sets have been created in place of the corresponding node-based surfaces so they can be used in ABAQUS/CAE.
Node Set Created            Node-Based Surface  
------------------          --------------------
    CHIP_CNS_                    CHIP_CNS_
    WORKPIECESURFACE_CNS_        WORKPIECESURFACE_CNS_
The interaction property "FLAKE-WP" has been created.
The interaction property "RAKE-WP" has been created.
The interaction property "SELF-CONTACE" has been created.
The interaction "FLAKE-WP-1" has been created.
The interaction "RAKE-WP-1" has been created.
The interaction "SELF-CONTACT-1" has been created.
WARNING: The following keywords/parameters are not yet supported by the input file reader:
---------------------------------------------------------------------------------
*SECTIONCONTROLS, ELEMENTDELETION
The model "Job-100" has been imported from an input file.
Please scroll up to check for error and warning messages.

zhangmeng

*SECTIONCONTROLS, ELEMENTDELETION
这一句abaqus不认识
可能是大小写或空格的问题

Seven

有些关键字在CAE中是不支持，如要再次添加到keywords中。

chenzwboy

里面不是提示了么？基于节点定义的平面不为 ABAQUS/CAE所支持。
Node-based surfaces are not yet supported in ABAQUS/CAE. The following node sets have been created in place of the corresponding node-based surfaces so they can be used in ABAQUS/CAE.