|
|
马上注册，结交更多好友，享用更多功能，让你轻松玩转社区。
您需要 登录 才可以下载或查看，没有账号？我要加入
x
本帖最后由 song0404 于 2013-1-27 15:01 编辑
求教各位大神，ansys里面设置模态阻尼比的命令MDAMP到底怎么用呢？帮助文件看了半天也没看明白，比如说我要设置1~10阶阻尼比为0.01,11~20为0.02，应该怎么写呢？跪求！
MDAMP
MDAMP, STLOC, V1, V2, V3, V4, V5, V6
Defines the damping ratios as a function of mode.
TLOC Starting location in table for entering data. For example, if STLOC = 1, data input in the V1 field applies to the first constant in the table. If STLOC= 7, data input in the V1 field applies to the seventh constant in the table, etc. Defaults to the last location filled + 1.
V1, V2,V3, . . . , V6 Data assigned to six locations starting with STLOC.If a value is already in this location, it will be redefined. Blank values for V2 to V6 leave the corresponding previous value unchanged.
|
|
发表于 2013-1-27 15:00
提升卡
变色卡
显身卡
楼主