求教：这个该如何划分6面体网格
/PREP7ET,1,FLUID30
ET,2,FLUID29
R,1, ,
R,2, ,
CYLIND,0.025, ,0.425,0,0,90,
wpro,,-90.000000,
CYLIND,0.025, ,0.425,0,-90,0,
!vsbv,1,2,,,keep
wpro,,90.000000,
wpro,,,90.000000
CONE,0.425,0.375,0,0.2,90,180,
VOVLAP,all
VDELE,5,6,1
Vglue,all
KWPLAN,-1, 1, 19, 2
vsbw,all
KWPLAN,-1, 19, 20, 10
wpro,,,90.000000
vsbw,all
wpro,,90.000000,
vsbw,all
我是这么切割的，但是总是有最小的一块，怎么也没有办法分网成6面体
最好有分网的命令流
先谢谢了
[ 本帖最后由 yesangle 于 2010-2-10 20:49 编辑 ] 对于这一小块
我用mesh 出现提示Meshing failure in volume 4 due to poor element quality
我用wsweep出现提示An error occured during sweeping while meshing area 12.Change element
sizing parameters (ESIZE, LESIZE, etc.), or mesh this area manually
(AMESH or AMAP) then try the VSWE command again.The VSWE command is
ignored.
实在是不知道要怎么去划分
求教各位
知道的能够不吝赐教-------------
谢谢了
-----------------------------------
页:
[1]