曲轴柔性体替换刚性体时出问题
WARNING: The distance between the J marker and the I marker is 0.1256680455.(No warnings if less than +/-1.0E-003)
Revolute Joint = .MODEL_1.JOINT_13
I Marker = .MODEL_1.PART5.MARKER_25
J Marker = .MODEL_1.PART2_flex.MARKER_26
WARNING: The distance between the J marker and the I marker is 3.8422193915E-002.
(No warnings if less than +/-1.0E-003)
Revolute Joint = .MODEL_1.JOINT_14
I Marker = .MODEL_1.PART2_flex.MARKER_27
J Marker = .MODEL_1.ground.MARKER_28
WARNING: The markers for JOINT MODEL_1.JOINT_13 are not initially coincident.
The relative displacement between the markers, expressed in the
J marker coordinate frame is:
Delta X = 6.09265E-02 Delta Y = -8.46021E-05 Delta Z = -0.10991.
WARNING: The markers for JOINT MODEL_1.JOINT_14 are not initially coincident.
The relative displacement between the markers, expressed in the
J marker coordinate frame is:
Delta X = -9.26499E-04 Delta Y = 8.46021E-05 Delta Z = 3.84109E-02.
WARNING: The markers for JOINT MODEL_1.JOINT_13 are not initially coincident.
The relative displacement between the markers, expressed in the
J marker coordinate frame is:
Delta X = 6.09265E-02 Delta Y = -8.46021E-05 Delta Z = -0.10991.
WARNING: The markers for JOINT MODEL_1.JOINT_14 are not initially coincident.
The relative displacement between the markers, expressed in the
J marker coordinate frame is:
Delta X = -9.26499E-04 Delta Y = 8.46021E-05 Delta Z = 3.84109E-02.
WARNING: The corrector has not converged after 6 attempts. No. of iterations = 10.
ERROR: The simulation is terminating at time = 0.0.
ADAMS can not solve the equations of motion because the mechanism has
"locked up." At least one constraintcanno longer be satisfied.
ADAMS is unable to satisfy the constraint for: ??? .
ERROR: Lockup detected
哪位知道什么原因，请指教！谢谢
[ 本帖最后由 xzsjjn 于 2009-9-14 16:08 编辑 ] 我也遇到这个问题了。请问，您这个问题怎么解决的呢？
页:
[1]