请高手指点
我在做金属注射成形方面的模拟，在调用子程序后老是出现这种问题如下：There is zero HEAT FLUX everywhere in the model based on the default criterion. please check the value of the average HEAT FLUX during the current iteration to verify that the HEAT FLUX is small enough to be treated as zero. if not, please use the solution controls to reset the criterion for zero HEAT FLUX.ERROR里说：TOO MANY ATTEMPS FOR THIS INCREMENT.
请问一下这是哪里出错了。往高手指点一二。。。
页:
[1]