ansys中，施加热边界问题
问一下，在施加热对流边界条件时，需要知道体的温度和散热系数，请问一下，
体的温度不知道是不是可以不用写入
sfa,area,conve,散热系数，体温度
体温度不用写可以吗 ？
还有谁知道铝合金7075的散热系数
谢谢 体没有对流吧？SFA的命令：Specifies surface loads on the selected areas
Table 2.10Load Commands for a Thermal Analysis
Load Type Solid or FE Model Entity Apply Delete List Operate Settings
Temperature Solid Model Keypoints DK DKDELE DKLIST DTRAN -
" Finite Element Nodes D DDELE DLIST DSCALE DCUM, TUNIF
Heat Flow Rate Solid Model Keypoints FK FKDELE FKLIST FTRAN -
" Finite Element Nodes F FDELE FLIST FSCALE FCUM
Convection, Heat Flux Solid Model Lines SFL SFLDELE SFLLIST SFTRAN SFGRAD
" Solid Model Areas SFA SFADELE SFALIST SFTRAN SFGRAD
" Finite Element Nodes SF SFDELE SFLIST SFSCALE SFGRAD, SFCUM
" Finite Element Elements SFE SFEDELE SFELIST SFSCALE SFBEAM, SFCUM, SFFUN, SFGRAD
Heat Generation Rate Solid Model Keypoints BFK BFKDELE BFKLIST BFTRAN -
" Solid Model Lines BFL BFLDELE BFLLIST BFTRAN -
" Solid Model Areas BFA BFADELE BFALIST BFTRAN -
" Solid Model Volumes BFV BFVDELE BFVLIST BFTRAN -
" Finite Element Nodes BF BFDELE BFLIST BFSCALE BFCUM
" " Elements BFE BFEDELE BFELIST BFSCALE BFCUM
你看。我对体施加温度载荷的方法是选择其中所有节点，用D施加温度，对于对流，应该是面的，选中其面，施加对流即可。温度是外表空气或液体的温度，应该不是体温度吧？ 赞同楼上的对于对流，应该是面的
谢谢
谢谢楼上，非常感谢ansys在求解结构问题是出现的知名错误
我是利用生死单元来杀死45号单元，模型中单元总数120*2*140在出现的错误如下：
*** FATAL *** CP = 187.969 TIME= 14:46:50
Element information missing for element 1.
************************************************************************
The above error is non-recoverable by ANSYS
ANSYS run terminated by the indicated error
Current data base saved if possible.
************************************************************************
还有一个：不知道是什么原因
*** WARNING *** CP = 184.422 TIME= 14:46:40
Out of the 33840 defined elements, only 2 elements are selected.
请大侠帮忙
页:
[1]