guo721 发表于 2008-8-27 20:12

帮忙看看我的图形！


如何才能把两个圆柱立起来啊，我怎么整也整不过来，请帮帮忙吧，谢谢啦！！

16443 发表于 2008-8-28 08:42

回复 楼主 guo721 的帖子

在柱坐标系做Y轴的move

sogooda 发表于 2008-8-28 10:53

/vup

16443 发表于 2008-8-29 14:33

回复 板凳 sogooda 的帖子

这个命令好。
/VUP, WN, Label
Specifies the global Cartesian coordinate system reference orientation.
GRAPHICS: Views
WN
Window number (or ALL) to which command applies (defaults to 1).

Label
Orientation:

Y    —Y vertical upward, X horizontal to the right, Z out from the screen (default).

-Y    —Y vertical downward, X horizontal to the left, Z out from the screen.

X    —X vertical upward, Y horizontal to the left, Z out from the screen.

-X    —X vertical downward, Y horizontal to the right, Z out from the screen.

Z    —Z vertical upward, Y horizontal to the right, X out from the screen. With this choice, you should use a view other than the /VIEW default of (0,0,1).

-Z    —Z vertical downward, Y horizontal to the left, X out from the screen. With this choice, you should use a view other than the /VIEW default of (0,0,1).
页: [1]
查看完整版本: 帮忙看看我的图形！