请高手看一下f06文件里的错误
以下是错误信息，是不是硬盘空间不够啊？请问做4万个点的solid的频率响应大约要多少的硬盘空间啊？USER FATAL MESSAGE 1250 (BIOWRT)
STATUS = 112, FILX = 1, LOGNAME = SCRATCH , NSBUF3 = 8192
FILE = d:/scratch/ug_zu3.T2788_30.SCRATCH
BLKNBR = 55160
ERROR MESSAGE IS --
磁盘空间不足?
BIOMSG: ERROR 923 HAS OCCURRED IN ROUTINE IONAST, FILE INDEX = 1.
LOGICAL NAME IS SCRATCH
FILENAME IS d:/scratch/ug_zu3.T2788_30.SCRATCH
STATUS = 112
********* NASTRAN FILE TABLE *********
INDEXLOGNAME STREAM_ID NAME
1SCRATCH 00000001 d:/scratch/ug_zu3.T2788_30.SCRATCH
2OBJSCR 00000002 d:/scratch/ug_zu3.T2788_30.OBJSCR
3MASTER 00000003 ./ug_zu3.MASTER
4DBALL 00000004 ./ug_zu3.DBALL
5SCR300 00000005 d:/scratch/ug_zu3.T2788_30.SCR300
6MASTERA FFFFFFFA f:/msc.software/msc.nastran/msc2005/i386/SSS.MASTERA
7MSCOBJ FFFFFFF9 f:/msc.software/msc.nastran/msc2005/i386/SSS.MSCOBJ
*** SYSTEM FATAL MESSAGE 4276 (IONAST)
ERROR CODE 923 PID= 0
USER INFORMATION: THIS ERROR MAY BE CAUSED BY EXCEEDING THE CAPACITY OF A SYSTEM RESOURCE.
(E.G., ALLOCATED DISK IS FULL, OR MAXIMUM FILE SIZE HAS BEEN REACHED)
*** USER INFORMATION MESSAGE 4276 (IONAST)
TO OBTAIN A NASTRAN DUMP RESUBMIT JOB WITH DIAG 44 INSERTED IN THE EXECUTIVE CONTROL SECTION.
1 * * * END OF JOB * * * 应该是硬盘空间不够。
至于 4 万个节点的疲劳响应需要多少空间，与你的输出请求有关，输出的内容越多 (位移、速度、加速度、单元应力等)，占有的空间越大。要减少占用空间，可以：
1 减少输出项目
2 采用 set 定义，只对整个模型中感兴趣的部分进行输出
可能还有其它办法，大家一起想吧。 Htbbzzg好活跃啊，一般采用减少输出选项
页:
[1]